EVS XTnano Version 10.04 - January 2011 Configuration Manual - Manual (Page 10)

Issue
10.04.A XTnano – Version 10.04 – Configuration Manual
EVS Broadcast Equipment SA – January 2011
2
2. Setup in Multicam
2.1 INTRODUCTION
2.1.1 O
VERVIEW
When you work in Spotbox mode, the ‘Setup Configuration’ module available in
the Multicam application, using the SHIFT + F2 keyboard combination, allows you
to configure the Multicam software and define server settings in relation to
timecodes, protocol communication, etc.
The other Multicam modules are discussed in the following manuals:
• Monitoring modules in the XTnano Tech Ref Software manual
• Multicam application in the User manual
This module contains several pages, or screens, which are described in details in
this section:
Setup page and section
name
Content
Page 1
See Section 2.2 ‘General
Settings (Page 1)’,
on page 4.
It includes several general settings on the
timecodes, the OSD, the VGA, the clip
management, the record trains, the channel
names.
Page 2
See Section 2.3 ‘VITC/ANC
Timecode Management (Page
2)’, on page 11
It includes detailed settings on the insertion of
VITC or ANC timecodes, channel by channel.
Page 3
See section 2.4 ‘SMPTE
334M Packets Management
(Page 3)’, on page 15.
It includes settings on the SMPTE 334M packet
management.
Page 4
See section 2.5 ‘GPI Settings
(Page 4), on page 17
It includes the settings on the GPIs IN and OUT