EVS XTnano Version 10.04 - January 2011 Configuration Manual - Manual (Page 31)

XTnano – Version 10.04 – Configuration Manual
EVS Broadcast Equipment SA – January 2011
Issue
10.04.A
23
2.7 LAN CONNECTION SETTINGS (PAGE 6)
2.7.1 I
NTRODUCTION
The settings for the connection with the MTPC board are defined in the Setup
Configuration module, on page 6.
This will allow interaction between the LAN and the MTPC board for the purpose
of system maintenance. The MTPC board and another workstation on the XNet
network will communicate through telnet or FTP access.
The XNet Monitor will use the LAN IP connection to transfer the monitoring data.
2.7.2 S
ETTINGS
D
ESCRIPTION
The MTPC board connection settings are described in the table below:
Port #1
IP Address Specifies the IP address to connect to the port 1 of the
MTPC board on the server. The IP addresses 0.0.0.0 and
255.255.255.255 are not allowed.
Subnet Mask Specifies the range of logical addresses within the address
space assigned to the MTPC board connection.
Default Gateway Specifies the IP address of the router on the XNet network
that the MTPC board can use as an access point to external
networks.