5 how to select and to modify parameters, 6 how to reset the default values, How to select and to modify parameters – EVS XTnano Version 10.04 - January 2011 Configuration Manual User Manual
Page 39: How to reset the default values
XTnano – Version 10.04 – Configuration Manual
EVS Broadcast Equipment SA – January 2011
Issue
10.04.A
31
•
To leave a section and go back to the main page of the Setup menu (see
screenshot below), press the MENU key.
•
To exit the Setup menu when you are in the main page of the Setup menu,
press the MENU key.
3.5 HOW TO SELECT AND TO MODIFY
PARAMETERS
To modify the parameters, you can proceed as follows for most of the parameters:
1.
Go to the desired page as explained in the Section 3.4.
2.
Select the parameter to be modified by pressing the corresponding F_ key.
3.
Make adjustment by rotating the jog dial.
4.
Press the corresponding F_ key again to validate the modification.
5.
Press MENU to return to the main page of the Setup menu.
3.6 HOW TO RESET THE DEFAULT VALUES
To restore the default value of a parameter in the Setup menu, proceed as
follows:
1.
Go to the desired page as explained in the Section 3.4.
2.
Press CLEAR and the F_ key that corresponds to the parameter on which
to restore the default value. Confirm the action.
To restore the default values on the entire Setup menu, press CLEAR + F0 and
confirm the action.