Spicer Dana Spicer Steer Axles - Service Manaul User Manual
Page 30
26
Disassembly, Overhaul, and
Assembly
Disassembl
y, Overhaul,
and Assembl
y
16. Seat draw key with a hammer and punch.
17. Install draw key nut and tighten. Refer to torque
charts in Appendix.
18. Ensure draw key is fully seated by repeating step 16
and 17. Recheck draw key nut torque.
19. Install kingpin caps. Tighten caps. Refer to torque
charts in Appendix.
Note: Tighten nut to range minimum in steps 17 and 19, then
tighten just enough to align cotter pin hole.
20. Attach drag link to steering arm. Install and torque
nut to vehicle manufacturer recommended torque.
21. Install cotter pin.
22. Attach tie rod end to tie rod arm on knuckle. Install
nut and tighten. Refer to torque charts in Appendix.
23. Install cotter pin.
24. Grease all kingpin and tie rod assemblies.
1 - Draw key
2 - Brass hammer
1 - Draw key nut
1
2
1