Spicer Single Speed Axle - Service Manual - Manual (Page 16)

Figure 3-22
Step (24) Assemble the outer pinion bearing cup into
carrier as shown. Make sure cup is seated.
TOOL: C-4171 Handle
C-4308 Bearing Cup Installer
Figure 3-23
Step (25) Assemble master pinion bearing on pinion.
TOOL: C-4204 Bearing Cup lnstaller
Figure 3-24
Step (26) Assemble pinion with master bearing into
housing. Assemble outer pinion bearing cone, end yoke,
washer, and nut. Torque nut until pinion gear and master
bearing is snug (seated) in housing. The pinion gear should
not have any end play. NOTE: Do not try to rotate pinion
using master bearing.
Figure 3-25
Step (27) Place arbor discs (large diameter) and arbor into
cross bores of carrier as shown.
TOOL: 6776 Dummy Differential Bearing Set
D-115 Arbor
WARNING: Gear teeth may have sharp
edges. When handling gears, use care to
avoid personal injury.
3-7