Spicer Single Speed Axle - Service Manual - Manual (Page 18)

Figure 3-30
Step (32) Place the required amount of shims (and
baffle if used) in the inner bearing bore. Drive the
inner bearing cup into the carrier. Make sure cup is
seated.
TOOL: C-4308 Bearing Cup Installer
C-4171 Handle
Figure 3-31
Step (33) Assemble inner bearing cone (and slinger if used)
on pinion. Drive bearing on shaft until it is
completely seated.
TOOL: D-389 Bearing Installer
Figure 3-32
Step (34) Assemble pinion into carrier. Assemble outer
pinion bearing cone, thrust washer, and end yoke onto
pinion spline.
NOTE
Do not assemble preload shims or pinion oil seal at
this time.
Use yoke installer as shown to assemble end
yoke onto spline of pinion.
TOOL: D- 191 Pinion Yoke Installer
6719 Yoke Holder
Figure 3-33
Step (35) Assemble washer and pinion nut. Torque nut
until it requires 10 Lbs. in. 1.13 Nom of torque to rotate
the pinion. Rotate pinion several times before checking
pinion position. This is to seat the bearings and assure a
more accurate reading when checking the pinion depth
setting.
TOOL: Torque Wrench
3-9