Spicer Single Speed Axle - Service Manual - Manual (Page 4)

SECTION 1
GENERAL INFORMATION
IMPORTANT SAFETY NOTICE
Should an axle assembly require component parts replacement, it is recommended that “Original Equip-
ment” replacement parts be used. They may be obtained through your local service dealer or other original
equipment manufacturer parts supplier. CAUTION: THE USE OF NON-ORIGINAL EQUIPMENT REPLACEMENT
PARTS IS NOT RECOMMENDED AS THEIR USE MAY CAUSE UNIT FAILURE AND/ OR AFFECT VEHICLE SAFETY.
Proper service and repair is important to the safe, reliable operation of all motor vehicles or driving axles
whether they be front or rear. The service procedures recommended and described in this service manual are
effective methods for performing service operations. Some of these service operations require the use of tools
specially designed for the purpose. The special tool should be used when and as recommended.
CAUTION: EXTREME CARE SHOULD BE EXERCISED WHEN WORKING ON COMPO- NENTS UTILIZING
SNAP RINGS OR SPRING LOADED RETENTION DEVICES. FOR PERSONAL SAFETY, IT IS RECOMMENDED
THAT INDUSTRIAL STRENGTH SAFETY GOGGLES OR GLASSES BE WORN WHENEVER REPAIR WORK IS
BEING DONE ON ANY VEHICLE OR VEHICLE COMPONENTS.
It is impossible to know, evaluate and advise the service trade of all conceivable ways in which service
might be done or of the possible hazardous consequences of each way.
Accordingly, anyone who uses a service procedure or tool which is not recommended must first satisfy
himself thoroughly that neither his safety or vehicle safety will be jeopardized by the service methods he
selects.
WARNING
Some vehicle manufacturers may require the assembly of brake components on Dana axles that utilize
materials containing asbestos fibers.
BREATHING ASBESTOS DUST MAY BE HAZARDOUS TO YOUR HEALTH AND MAY CAUSE SERIOUS
RESPIRATORY OR OTHER BODILY HARM.
Follow O.S.H.A. standards for proper protective devices to be used when working with asbestos materials.
SILICONE RUBBER SEALANT (RTV) AND LUBRICATING GREASE AND OILS
Silicone rubber sealant is used as a gasket material on Dana axles, as well as various lubricants for
lubricating purposes. Before using any of these materials, one should become familiar with and follow all
safety precautions as recommended by the product manufacturer/supplier. All personnel involved with these
materials should follow good industrial hygiene practices (e.g. before eating, hands and face should be
thoroughly washed. Eating, drinking and smoking should be prohibited in areas where there is potential for
significant exposure to these materials).
When discarding any of the materials, observe all local, state, and federal laws and regulations for proper
disposal procedures.
1-1