Spicer Dana Corporation Steer Knuckle Recall Identification and Repair Procedure - Manual (Page 10)

19. Install cotter pins into the drag link nuts.
20. Attach tie rod end to tie rod arm on knuckle. Install nut and tighten to 120-160 Lbf-Ft (163-217Nm).
21. Install cotter pin.
22. Grease all kingpin and tie rod assemblies as required.
STEERING KNUCKLE STOP ADJUSTMENT
1. Old Steering Stop Adjustment Screw must be re-installed onto new knuckle as per above procedure.
Figure 15
1 - Front of vehicle
2 - Steering knuckle
3 - Axle beam
4 - Steering stop adjustment (both ends of axle)
5 - Degree of steering angle
2. Check steering angle with alignment turntable set. Refer to OEM specification to determine the correct steering
angle for the truck:
10