Spicer Dana Corporation Steer Knuckle Recall Identification and Repair Procedure User Manual
Page 6
Advertising
5. Pre-adjust knuckle vertical play by wedging the steering knuckle up and filling the gap at the topside of the
knuckle with shim(s).
Figure 6
1 - Install shim(s) as needed
2 - Shim only top of knuckle
Note: Before installing the kingpins, lubricate inside of bushing and outside of kingpins with NLGI No. 2
multipurpose lithium grease to provide initial lubrication.
Note: Floor jack can be used to wedge up steering knuckle.
6. Install kingpin from the top with notch and draw keyholes aligned. Hand start in bushing.
Figure 7
1 - Kingpin
2 - Steering knuckle
CAUTION: Never shim between the thrust bear and the beam.
6
Advertising