Spicer Dana Corporation Steer Knuckle Recall Identification and Repair Procedure - Manual (Page 9)

13. Install new draw keys.
14. Seat draw keys with a hammer and punch.
1 - Draw key
2 - Brass hammer
15. Install draw key nuts and tighten to 30-45 Lbf-Ft (41-61 Nm).
1 - Draw key nut
16. Ensure draw key is fully seated by repeating step 13 and 14. Recheck draw key nut torque.
17. Install kingpin caps. Tighten caps to 50-75 Lbf-Ft (68-102 Nm).
18. Attach drag link to steering arm and Pitman arm. Install and torque nuts to 165-230 Lbf-Ft (224-312 Nm).
9