Spicer Convertible Tandem Axles - Manual (Page 24)

18
Drive Pinion
19. Once the proper rolling torque is achieved, use a
punch with a round tip to stake the pinion nuts
flange into the machined slot in the pinion shaft. See
diagram below.

The stake must be deep enough to enter the machined slot
of the pinion. See diagram below.

Failure to stake the pinion nut properly may result in the nut
coming loose during service. The pinion nut should never
be reused, always replace with new.
20. If a pilot bearing web is used, lineup the web to

the locating sleeves and tap in place with a rubber
mallet.
21. Install cap screws and torque to the proper specifi-
cations. See the Torque Chart.
TIP: If you are unable to torque the yoke nut cor-
rectly, try torquing the nut with the truck wheels on
the ground and with the axle shafts installed.
CAUTION
1 - Round Tipped Chisel
2 - Nuts Staking Flange
3 - Machined Slot In Pinion
1
2
3
WARNING
1
1
1 - Locating Sleeves