Install bowl tag housing cover – Spicer Convertible Tandem Axles User Manual
Page 43
Advertising
37
Housing Assembly
Housing Assembly
Install Bowl Tag Housing Cover
Axle Assembly Procedure
1.
Apply a 1/8” bead of Ultra gray sealant to the drive
axle housing to carrier interface. Make sure to apply
sealant around each bolt hole as shown.
2.
Install the housing cover plate using cap screw part
number 132820 and washer part number 130877.
3.
Torque cap screws in a cris-cross pattern to 250 +/-
10 lb-ft.
Advertising