Warrior 885 WRANGLER UNLIMITED RENEGADE RACK (2007 – 2013 Jeep JK Wrangler) - Manual

Protecting Your Adventure Lifestyle
========================================================================================
QUALITY • INTEGRITY • INNOVATION • SERVICE
Warrior Products, Inc.
16850 SW Upper Boones Ferry Rd
Ste. A
Durham, OR 97224
Phone (888) 220-6861
Fax (503) 692-0364
[email protected]
885 JK WRANGLER UNLIMITED RENEGADE RACK
INSTALLATION SHEET
Important Notes: Some brands of windshield light brackets and snorkels may not be compatible with the 885
Renegade Roof Rack System. Body lifts are also not compatible with this rack system. Please keep this in mind
when deciding upon any upgrades or accessories that may conflict with the racks’ mounting locations.
It is
recommended to have an additional person to assist you during some steps of this installation process. Some
customers may be sensitive to the wind noise generated by a roof rack. Mounting of the optional accessory ‘888
Renegade Air Dam’ can drastically reduce the amount of wind noise experienced.
Kit Contents:
Item Qty Item Qty Item Qty
A-pillar mount - D 1 Rear mount bracket - D 1 7/16” Flat washer 4
A-pillar mount - P 1 Rear mount bracket - P 1 8mm x 25mm Screw 6
Front leg - D 1 Pinch seam clamp - D 1 3/8” x 1” Carriage bolt 8
Front leg- P 1 Pinch seam clamp - P 1 3/8” Lock washer 8
Rear leg – D 1 _” x 3” SS Button head bolt 4 3/8” Regular nut 10
Rear leg – P 1 _” Lock washer 4 5/16” SS Flat head screw 8
Main basket 1 _” Regular nut 4 5/16” Lock washer 8
Front basket section 1 7/16” x 2.5” Bolt 4 5/16” Regular nut 8
Rear basket section 1 7/16” Lock washer 4 Urethane bump stop 2
_” Bushing sleeve 4 Urethane bushing 8
Phase 1: Mounting Brackets Installation
1. The side of the A-pillar has 4 Torx bolts per side. Remove
the top 3 and install the A-pillar mount with the 8mm flat
head Allen screws. Repeat for the opposite side. Fig. 1
Note: If you are at all concerned about possibly of damaging
the paint under the brackets, utilize a piece of bicycle inner
tube and trace around the mounting surface of the bracket.
Cut it out for a makeshift gasket.
2. The rear mount brackets are a little more involved. In most
cases, temporary removal of the rear bumper and related
bracketry is required.
3. Take the Rear Mount Bracket labeled ‘P’ (passenger side)
and match it up with the Pinch Seam Clamp labeled ‘P’.
Loosely thread the 7/16” x 2.5” bolts along with a 7/16”
lock washer and a 7/16” flat washer up through the bottom
of the Rear Mount Bracket and into the Pinch Seam Clamp.
Fig. 2
4. Hold the assembled passenger side bracket against the side of the frame where the factory bumper mount
holes are located. The pinch seam of the Jeep tub should set between the bracket and the clamp. Utilizing