Warrior 885 WRANGLER UNLIMITED RENEGADE RACK (2007 – 2013 Jeep JK Wrangler) User Manual
Page 2
Protecting Your Adventure Lifestyle
========================================================================================
QUALITY • INTEGRITY • INNOVATION • SERVICE
Warrior Products, Inc.
16850 SW Upper Boones Ferry Rd
Ste. A
Durham, OR 97224
Phone (888) 220-6861
Fax (503) 692-0364
a factory bumper side bolt, loosely thread one through the bottom hole of the bracket into the frame. This
is to hold the brackets into place while you slide the rear bumper back on. Repeat steps for the driver side.
Fig. 3
5. If you are reinstalling the factory plastic bumper, you will need to mount the bumper brackets on the
outside of the Rear Mount Brackets. If you are fitting an aftermarket bumper, you most likely will be
‘sandwiching’ the bumper mount brackets between the frame and the Rear Mount Brackets. This is why
the lower bolt is loosely threaded into the frame as it’s easier to pull that bolt quickly while fitting the
bumper and reinserting it after the bumper has been fully seated. It can be a bit of a juggle installing the
rear bumper while keeping the Rear Mount Brackets in their correct positions, so an extra set of hands is
very helpful. Once you have the rear bumper set all the way on and the mounting holes lined up, thread
the remaining factory bolts through the Rear Mount Brackets and into the frame and tighten them. Now
tighten the Pinch Seam Clamp bolts to complete this step in the process. Fig. 4 & Fig. 5
Note: For additional strength of the rear mounts, provisions have been made to add carriage bolts through the u-
shaped part of the bracket and through the top surface of the bumper endcaps. Spacers may need to be fabricated
to close the gap between the two surfaces. (Hardware not provided)