Warrior 885 WRANGLER UNLIMITED RENEGADE RACK (2007 – 2013 Jeep JK Wrangler) User Manual
Page 4
Protecting Your Adventure Lifestyle
========================================================================================
QUALITY • INTEGRITY • INNOVATION • SERVICE
Warrior Products, Inc.
16850 SW Upper Boones Ferry Rd
Ste. A
Durham, OR 97224
Phone (888) 220-6861
Fax (503) 692-0364
5. Repeat for the front basket section.
6. Once the bolts for the front and rear basket sections have been tightened, now tighten the 3/8” carriage
bolts at all four corners.
7. If the rack requires side-to-side positioning or stiffening, this can be accomplished by adjusting the rear
legs bump stops against the Jeep tub and locking into place with the 3/8” nut on the bump stop stud.
Installation of your Renegade Rack is now complete.
Hard Top Removal Notes
It is not necessary to remove the rack to remove the hard top. The Freedom Panels will lift out normally
without much interference from the rack and the main section of the hard top will slide out the back.
Soft Top Removal Notes
IMPORTANT NOTE: The factory license plate holder obstructs the ability to pivot the rack backwards for
soft top folding. Warrior offers part #2370 & #2380 ‘Spare Tire License Plate Mount’ to relocate the license
plate to the center of the spare tire. WP recommends that you then use dealer part ‘Jeep JK OEM License Plate
Hole Cover PN 55397112AA’ to cover the hole that is exposed by removing the factory license mount.
To fold the soft top you will need to follow these steps:
1. DO NOT ATTEMPT TO SPLIT AND PIVOT THE RACK SYSTEM WITH THE CARGO
BASKET LOADED. In Addition, the soft top will need to be stowed all the way back. There is
not enough room under the rack to run the top in ‘Sun-Rider’ mode. Remove the (4) 3/8” x 1”
carriage bolts from the front mounting plates. Due to the weight of the basket, having an assistant
help with this next step is recommended. With a person on both sides of the Jeep, grab the rear legs
and pivot them back along with the main
basket and then have your assistant hold the
basket/legs unit off the ground while the soft
top is folded. Alternatively, you could pivot
and prop the basket/rear legs unit off the
ground with saw horses or something
similar.
2. Gently pivot the front basket section forward
and it will rest upon stops built into the A-
pillar mounts. Fold and stow soft top
completely back.
3. Once the soft top is stowed, pivot the front
section back into position then have your
assistant help pivot the main basket/leg
section back to its normal position. Reinstall the 3/8” x 1” carriage bolts with associated hardware and
tighten.
If you need further assistance installing your product, please contact us by email at
or call us at (888) 220-6861.
THANK YOU FOR PURCHASING WARRIOR PRODUCTS