Warrior 885 WRANGLER UNLIMITED RENEGADE RACK (2007 – 2013 Jeep JK Wrangler) User Manual
Page 3
Protecting Your Adventure Lifestyle
========================================================================================
QUALITY • INTEGRITY • INNOVATION • SERVICE
Warrior Products, Inc.
16850 SW Upper Boones Ferry Rd
Ste. A
Durham, OR 97224
Phone (888) 220-6861
Fax (503) 692-0364
Phase 2: Rack Legs Installation
1. Begin by assembling the urethane bushings and _” metal sleeves into the pivoting tubes at the bottom of
each leg. A mallet and some WD40 will help facilitate the process.
2. Mount the front legs to their respective ‘D’ and ‘P’ sides with the _” x 3.0” SS button head bolts. A _”
lock washer followed by a _” regular nut completes this step. The front legs can be pivoted forward till
they rest upon the A-pillar mounts’ built in stops.
3. OPTIONAL STEP: There are urethane bump stops included in the kit
that you may choose to install that will stiffen the rack system against
the Jeeps’ tub. The bump stops will rest directly against the tub and may
rub against the paint, so if this is a concern to you take the necessary
steps to prevent this. Begin by taking the urethane bump stops and
threading a 3/8” regular nut all the way onto the threads so the nut stops
against the urethane. Each rear leg has gusset with a 3/8” threaded
mount. Thread the urethane bump stop into this mount till it stops
against the 3/8” nut welded to the leg gusset.
4. Finally, mount the rear legs into their respective ‘D’ and ‘P’ sides with the _” x 3.0” SS button head bolts,
lock washers and nuts. The top of the legs can lightly rest against the Jeeps’ top or you can use a couple
blocks of wood to space it away.
Phase 3: Main Basket Install Steps
1. With the aid of an assistant, lift the main basket into
place onto the roof of the Jeep. Place a small block of
wood (short pieces of 2x4 are perfect) under each
corner of the basket to position the mounting plates
in line with the mounting plates of the legs.
2. Working at one corner at a time, take the (8) 5/16” x
1” flat head screws and place them through the
countersunk holes in each mounting plate at the top
of the legs. Next, place the (8) 3/8” x 1” carriage
bolts through the main baskets’ square holes in the
mounting plates so the threads go through the
corresponding holes in the legs mounting plates.
Place a 3/8” lock washer and 3/8” regular nut on each
carriage bolt and hand tighten them. Don’t crank
them tight just yet, as you want a little movement
while you’re still placing the rest of the componentry
together. Fig. 6
3. With the mounting plates all lightly bolted together,
remove the wood blocks.
4. Take the rear basket section and fit the mounting plate ends over the threads on the 5/16” x 1” flat head
screws that are now sandwiched between the mounting plates of the basket and the rear legs. Thread on
the 5/16” lock washers and regular nuts and tighten. There are access holes through the basket end plates
to utilize an Allen wrench if needed.