VEGA VEGAPULS 65 (≥ 2.0.0 - ≤ 3.8) Foundation Fieldbus User Manual

Page 49

Advertising
background image

1,0 m (3.28 ft)

30 m (98.43 ft)

20 mm (0.788 in)

10 mm (0.394 in)

- 10 mm (- 0.394 in)

- 20 mm (- 0.788 in)

0

Fig. 29: Deviation VEGAPULS 65

Influence of the ambient temperature to the sensor electronics

6)

Average temperature coefficient of the zero
signal (temperature error)

0.03 %/10 K

Influence of the superimposed gas and pressure to the accuracy

The spreading speed of the radar impulses in gas or vapour above the product is reduced by high
pressures. This effect depends on the superimposed gas or vapour and increases with low
temperatures. The following chart shows the deviation caused by some typical gases or vapours.
The stated values refer to the distance. Positive values mean that the measured distance is too
high, negative values that the measured distance is too small.

Gas phase

Temperature

1 bar/14.5 psig

10 bar/145 psig

50 bar/725 psig

Air/Nitrogen

20 °C/68 °F

0.00 %

0.22 %

1.2 %

Air/Nitrogen

200 °C/392 °F

0.00 %

0.13 %

0.74 %

Hydrogen

20 °C/68 °F

-0.01 %

0.10 %

0.61 %

Hydrogen

200 °C/392 °F

-0.02 %

0.05 %

0.37 %

Water (saturated
steam)

100 °C/212 °F

0.20 %

-

-

Water (saturated
steam)

180 °C/356 °F

-

2.1 %

-

Ambient conditions

Ambient, storage and transport temperature

-40 … +80 °C (-40 … +176 °F)

Process conditions

For the vessel pressure, you also have to note the specifications on the type label. Always the
lowest value is applicable.

6)

Relating to the nominal measuring range, in the temperature range
-40 … +80 °C .

VEGAPULS

65 • Foundation Fieldbus

49

10 Supplement

28452

-EN

-090305

Advertising