VEGA VEGACAP 35 - Relay (DPDT) - Manual (Page 24)

24
7 Maintenance and fault rectification
VEGACAP 35 • - Relay (DPDT)
33759-EN-130916
1
2
8
3
4
5
6
7
Fig. 24: Shortening of the cable probe
1 Upper part of the weight
2 O-rings
3 Isolating socket
4 Locking sleeve
5 Pins
6 Insulating sleeve
7 Lower part of the weight
8 Pin
1. Unscrew pin (8)
2. Unscrew the lower part of the weight (7)
3. Shift the upper part of the weight (1), the four O-rings (2) and the
insulating sleeve (3) upward above the planned curring site.
4. Remove the insulating sleeve (6) from the locking sleeve (4).
5. Loosen the two pins (5) on the locking sleeve (4).