5 how to proceed in case of repair – VEGA VEGACAP 35 - Relay (DPDT) User Manual
Page 25
25
7 Maintenance and fault rectification
VEGACAP 35 • - Relay (DPDT)
33759-EN-130916
6. Pull the cable out of the locking sleeve (4).
7. To avoid splicing of the steel cable, tin the cable before shortening
with a soldering iron and tighten the wire.
8. Shorten the cable with a cut-off wheel or a metal saw at the lower
end. Make sure the length is correct before shortening.
9. Shorten the insulation of the cable with a sharp knife by 60 mm
(2.36 in).
10. Shift the chamfered side of the locking sleeve (4) with a rotary
movement onto the cable.
Make sure that the cable is flush with the lower side of the locking
sleeve (4).
11. Lock the cable with the two pins (5).
Make sure that the cable screen has no contact to the inner steel
cable.
12. Shift the isolating sleeve (6) onto the locking sleeve (4).
13. Shift the lower part of the weight (7) to the upper part of the
weight (1) and screw them together.
14. Lock the upper part of the weight (1) with pin (8).
15. Check the correct length of the probe.
16. Carry out a fresh adjustment. See chapter "Set up, new adjust-
ment".
7.5 How to proceed in case of repair
You can find a repair form as well as detailed information on how to
pr and "Forms and certifi-
cates".
By doing this you help us carry out the repair quickly and without hav-
ing to call back for needed information.
If a repair is necessary, please proceed as follows:
•
Print and fill out one form per instrument
•
Clean the instrument and pack it damage-proof
•
Attach the completed form and, if need be, also a safety data
sheet outside on the packaging
•
Please contact for the return shipment the agency serving you. You
can find the agency on our home page