6 set up, 1 general information, 2 adjustment elements – VEGA VEGAKON 61 - Relay (DPDT) User Manual
Page 14: 3 functional chart, 6set up
6
Set up
6
.1 General information
On the electronics module you will find the following indicating and
adjustment elements:
l
DIL switch for mode adjustment
l
Control lamp for indication of the switching status
6
.2 Adjustment elements
1
2
3
4
1
Type label
2
Signal lamp (LED)
3
Connection terminals
4
Mode switch (A/B)
With the mode adjustment (A/B) you can change the switching
condition of the output. You can set the required mode according to
the "Function chart" (A - max. detection or overflow protection, B - min.
detection or dry run protection).
The switching condition of the signal lamp can be checked when the
housing is closed. To adjust VEGAKON 61 loosen the four screws with
a wrench on the upper side of the instrument and remove the housing
cover.
6
.3 Functional chart
The following chart provides an overview of the switching conditions
depending on the adjusted mode and level.
Function/Configuration
Mode adjustment (4)
Signal lamp (2)
14
VEGAKON
61 • - Relay (DPDT)
6 Set up
32647
-EN
-100219