AEG MCC2580E-M - Manual (Page 159)

MCC2580E-m
159
Installation
7. Remove any promotion label from
the door.
8. The oven should be installed on a
flat, level surface. The surface must
be strong enough to safely bear
the weight (35 kg) of the oven, and
the contents. To avoid the
possibility of causing vibration or
noise the oven must be in a stable
position.
9. Keep the oven away from heat and
water. Exposure to heat and water
can lower oven efficiency and lead
to malfunctioning, so be sure to
install the oven away from heat and
water sources.
10. Do not block air vents on the top
and the sides of the cabinet and
also do not place any articles on
the top of the oven. If air vents are
blocked during operation, the oven
may overheat, and this may lead to
malfunctioning. Hot air escapes
from the vents so be sure not to
obstruct it or let curtains come
between the oven and the rear wall.
11. Place the oven as far away from
radios and TV’s as possible. This
oven does conform to EEC
requirements of radio interference
suppression, but some interference
may occur if it is placed too close
to a radio or TV, so keep them as
far apart as possible.
12. If positioned in a corner, leave a
gap of at least 15cm from the walls
and 15cm above the microwave.
The oven can be placed almost
anywhere in the kitchen. Make sure the
oven is placed on a flat, level surface
and that vents as well as the surface
underneath the oven are not blocked
(for sufficient ventilation).
Connecting to the mains
The oven is delivered with the power
cord and a plug for 230V, 50Hz,
earthed socket outlet.
Earth protection minimises the risks
should a short circuit occur. Check to
ensure the voltage of the oven matches
the supply.
If the oven is connected to the socket
via an extension cord, make sure the
cord is earthed.
This appliance must not be used on a
non-earth protected power supply.
Contact an electrician if you are
uncertain regarding electrical
connection of the oven or provision of
earth protection of the
supply.