VEGA PLICSRADIO R61 Wireless indicating unit - Manual (Page 20)

20
6 Setup with the integrated display and adjustment unit
PLICSRADIO D61 • Wireless indicating unit (single channel)
32626-EN-130228
2. Select the menu item "Device settings" with [->] and confirm with
[OK].
You can assign an unambiguous name to PLICSRADIO D61 via the
Device-TAG. This function is recommended when several instruments
are implemented and a good documentation of larger systems is
required.
→
Enter the requested values via the appropriate keys and save
your settings with [OK].
The emitting and receiving units must be always set to the same radio
channel. When using several independent radio links, each radio link
must be provided with a different channel. In total, seven radio links
are available (channel 0 … 6).
→
Enter the values via the appropriate keys and save your settings
with [OK].
To protect the radio connection against unauthorized wiretapping, the
transmission should be protected by a radio PIN. To do that, activate
this function and enter any PIN (0001-9999).
→
Enter the values via the appropriate keys and save your settings
with [OK].
Enter the address of the emitting unit which delivers the requested
measured value.
→
Enter the requested parameters via the appropriate keys and
save your settings with [OK].
If the requested measured value is delivered by a PLICSRADIO T62,
it is also necessary to select the corresponding input (1 … 3).
Device settings - Device-
TAG
Device settings - Radio
channel
Device settings - Safe
operating mode
Device settings - Address
Device settings - Device
value