VEGA PLICSRADIO R61 Wireless indicating unit - Manual (Page 21)

21
6 Setup with the integrated display and adjustment unit
PLICSRADIO D61 • Wireless indicating unit (single channel)
32626-EN-130228
The displayed value determines which measured value is displayed.
For VEGA sensors "Percent", "lin. percent", "Scaled" and "Sensor
value" are available. The parameterisation of the connected sensor is
based on the settings "Percent", "lin. percent" and "Scaled".
For sensors of other manufacturers, the percentage value is read out
with HART command 2. Only connect instruments supporting this
command correctly.
Enter the values via the appropriate keys and save your settings with
[OK].
When the instrument displays a failure message, further information is
available under the menu item "Diagnosis - Device status".
The service menu contains the following settings:
•
Reset
•
Set display language
•
PIN to block the menu
With a reset to default, all settings will be reset to default except the
language selection.
Note:
Since the radio parameters are also reset to default, the communica-
tion can be interrupted.
In the menu item "Info" the following information is available:
•
Sensor type and serial number
•
Date of manufacture and software version
•
Date of last change using PC
•
Features of PLICSRADIO D61
Display - Displayed value
Diagnostics
Service
Service - Reset
Info