VEGA PLICSMOBILE GSM_GPRS radio module - Manual (Page 12)

5 Set up
5 .1 Adjustment system
A pC with PACTware and respective DTM is required for setup.
The connection is carried out via a standard mini USB cable (in the
scope of delivery). A released SIM card with data transmission option
must be used in PLICSMOBILE. A good network coverage of the used
GSM/GPRS network must be available at the place of operation.
Adjustment on the instrument is limited to a test key and an LED. With
these, the operation and the status of the instruments can be checked
(selection of the GSM network, standby …).
4
1 3
2
USB
Status
Test
SIM-Card
Fig. 4: Indicating and adjustment elements
1 SIM card slot
2 Status indication
3 Key to the test operation
4 Mini-USB interface
Information:
The function description of the key and the status indication is
available in chapter "Mobile phone network and SIM card".
5 .2 Connecting the PC
The parameter adjustment of PLICSMOBILE is carried out via PC and
USB interface. The required connection is located in the electronics
housing. Keep in mind that proper functioning of the USB interface can
only be guaranteed in the (limited) temperature range of 0 … +60 °C.
If the PC is provided with a Full-Power-USB-Port, the PLICSMOBILE is
powered via the integrated USB power supply. Parameter adjustment
is thus possible without connected power supply, but measured value
recording and transmission is not possible. Power supply via USB is
not possible with a Low-Power-USB-Port.
Setup requirements
Indicating and adjust-
ment elements
Connection of the PC via
USB
12 PLICSMOBILE • GSM/GPRS radio module
5 Set up
36849
-EN
-111221