VEGA VEGAPULS 68 (≥ 2.0.0 - ≥ 4.0.0) Modbus and Levelmaster protocol - Manual (Page 13)

13
3 Product description
VEGAPULS 68 • Modbus and Levelmaster protocol
41370-EN-121011
You can find further information in the operating instructions "Interface
adapter VEGACONNECT" (Document-ID 32628).
The protective cover protects the sensor housing against soiling and
intense heat from solar radiation.
You will find additional information in the supplementary instructions
manual "Protective cover" (Document-ID 34296).
Screwed flanges are available in different versions according to the
following standards: DIN 2501, EN 1092-1, ANSI B 16.5, JIS B 2210-
1984, GOST 12821-80.
You can find additional information in the supplementary instructions
manual "Flanges according to DIN-EN-ASME-JIS" (Document-ID
31088).
The electronics module VEGAPULS series 60 is a replacement part
for radar sensors of VEGAPULS series 60. There is a different version
available for each type of signal output.
You can find further information in the operating instructions "Elec-
tronics module VEGAPULS series 60" (Document-ID 36801).
The electronics module Modbus is a replacement part for radar sen-
sors of VEGAPULS series 60. A separate version is available for each
type of signal output.
You can find further information in the operating instructions "Elec-
tronics module Modbus VEGAPULS series 60" (Document-ID 41864).
The antenna impedance cone is used for optimum transmission of
microwaves and for sealing against the process.
You find further information in the operating instructions "Antenna
impedance cone VEGAPULS 62 and 68" (Document-ID 31381).
Protective cover
Flanges
Electronics module
Electronics module,
Modbus
Antenna impedance cone