VEGA VEGAPULS 61 (≥ 2.0.0 - ≥ 4.0.0) 4 … 20 mA_HART four-wire Approval according to LPR radio standard - Manual (Page 13)

Fig. 2: Flange mounting of the radar sensor
4 .3 Mounting preparations, mounting strap
The mounting strap enables simple mounting on the vessel wall or silo
top. It is suitable for wall, ceiling or boom mounting. Especially in open
vessels this is a very easy and effective way to align the sensor to the
bulk solid surface.
The strap is supplied unassembled and must be screwed to the sensor
before setup with three hexagon screws M5 x 10 and spring washers.
Max. torque, see chapter "Technical data". Required tools: Allen
wrench size 4.
There are two ways to screw the strap onto the sensor. Depending on
the selected version, the sensors can be swivelled in the strap as
follows:
l Single chamber housing
-
Angle of inclination 180°, infinitely variable
-
Angle of inclination in three steps 0°, 90° and 180°
l Double chamber housing
-
Angle of inclination 90°, infinitely variable
-
Angle of inclination in two steps 0° and 90°
VEGAPULS 61 • Approval according to LPR radio standard 13
4 Mounting
41714
-EN
-120301