VEGA VEGAPULS 61 (≥ 2.0.0 - ≤ 3.8) 4 … 20 mA__HART two-wire - Manual (Page 33)

5 .6 Wiring plan - version IP 66/IP 68, 1 bar
+
-
1
2
Fig. 31: Wire assignment, connection cable
1 brown (+) and blue (-) to power supply or to the processing system
2 Shielding
5 .7 Switch on phase
A fter connecting VEGAPULS 61 to power supply or after a voltage
recurrence, the instrument carries out a self-check for approx. 30
seconds:
l I nternal check of the electronics
l I ndication of the instrument type, the firmware as well as the
sensor TAGs (sensor designation)
l O utput signal jumps briefly (approx. 10 seconds) to the set fault
current
T hen the corresponding current is outputted to the cable (the value
corresponds to the actual level as well as the settings already carried
out, e.g. factory setting).
Wire assignment, con-
nection cable
Switch on phase
VEGAPULS 61 • 4 … 20 mA/HART two-wire 33
5 C onnecting to power supply
28434
-EN
-100426