Velleman CAMCOLD24 - Manual (Page 11)

CAMCOLD24 - CAMCOLD24W
V. 02 – 30/05/2013 11 ©Velleman nv
 MOSAIC: creates a mosaic pattern in the privacy area. This
is useful if you want to make an area private, but still want
to use it for motion detection.
7.9 Day/night
The camera can switch automatically between colour images in day
conditions and black-and-white images in night conditions. Use this
function to control the day/night behaviour of the camera.
Note: black-and-white images are much clearer and contain less
noise at low light levels.
Display: DAY/NIGHT
COLOR Day/night mode is disabled and the camera always makes
colour images as in day mode.
B/W Day/night mode is disabled and the camera always makes
black and white images as in night mode.
 BURST: you can switch burst on or off to improve the
image quality. The burst function sends a colour signal to
the monitor in B/W mode. This may degrade the clarity
of the image.
 IR optimizer: Turning this setting on enables the user
to optimize IR settings through mode and level such as
reducing over-saturation in video images caused by the
different IR LEDs.
 MODE: There are two modes available to manage IR
optimizer. Auto mode reduces the over-saturation
automatically along with the location of the subject.
Center mode prioritizes the center area of the image to
reduce the over-saturation.
 LEVEL: High values for level increases the brightness,
over-saturation could still occur. Low values for level
decreases the brightness and the dim area could be
darker.
EXT 1 Day/night mode is switched by the external light sensor.
Note: The EXT setting should only be used for a camera
equipped with IR LEDs.
EXT 2 This mode is not used on the CAMCOLD24 - CAMCOLD24W.