Velleman CAMCOLD24 - Manual (Page 9)

CAMCOLD24 - CAMCOLD24W
V. 02 – 30/05/2013 9 ©Velleman nv
HLC Highlight compensation. Use this setting to compensate
for extreme differences between dark and light areas. For
example, if someone shines a bright light directly into the
lens, the entire image can become overexposed. With
HLC, the camera masks the bright area so that the area
around the light source is still visible.
7.5 Picture adjustment
These are the common adjustments for video images.
Display: PICT ADJUST
MIRROR
to mirror the image.
BRIGHTNESS to adjust the brightness of the image.
CONTRAST
to adjust the contrast of the image.
SHARPNESS to adjust the sharpness of the image.
HUE
to adjust the hue of the image.
GAIN to adjust the gain of the image.
7.6 ATR
Use the Adaptive Tone Reproduction (ATR) function to improve the
colour tones of subjects in images that contain both bright and dim
areas (for example, a wall with a window).
Note: ATR can introduce noise in night-time images.
Display: ATR
OFF ATR is switched off.
ON ATR is active. Use the settings below.
 LUMINANCE: to adjust luminance.
 CONTRAST: to adjust contrast.
7.7 Motion detection
Use this function to see motion detection during live monitoring. You
can use:
 Block display: in a grid of squares, select the areas where you
want to use motion detection. If the camera detects motion in one
of the enabled squares, the image in that square will ‘flash’.
 Monitor area selection: you can select up to 4 separate areas for
motion detection. If the camera detects motion, the outer edge of
the area will ‘flash’.