Alpine INA-W910R - Manual (Page 13)

INA-W910R Navigation Software Owner’s Manual 13
Default data fields when cruising without a destination (tap any of the fields to change its
value):
Field Description
Shows your current speed given by the GPS receiver.
Shows the speed limit of the current road if the map contains it.
Shows the current time corrected with time zone offset. The accurate
time comes from the GPS satellites, and the time zone information
comes from the map or it can be set manually in Regional settings.
Default data fields when navigating a route (tap and hold any of the fields to change its value):
Field Description
Shows the distance you need to travel on the route before reaching
your final destination.
Shows the time needed to reach the final destination of the route
based on information available for the remaining segments of the
route.
If your device is capable of receiving live traffic information, the
calculation takes into account traffic delays affecting your route if they
are received. However, this calculation is rarely accurate.
Historical traffic data can also be taken into account if data is
available.
Shows the estimated arrival time at the final destination of the route
based on information available for the remaining segments of the
route.
If your device is capable of receiving live traffic information, the
calculation takes into account traffic delays affecting your route if they
are received. However, this calculation is rarely accurate.
Historical traffic data can also be taken into account if data is
available.
2.3.2 Position markers
2.3.2.1 Vehimarker and Lock-on-Road
When your GPS position is available, the software marks your current position with the
Vehimarker. By default, this marker is a blue arrow, but you can change this icon in Settings.
The Vehimarker may not show your exact GPS position and heading. If roads are near, it is
aligned to the nearest road to suppress GPS position errors, and the direction of the icon is
aligned to the direction of the road.