PACKARD BELL dot s series User Manual

Page 29

Advertising
background image

Upgrading your computer - 27

Video port

Connect to a monitor with a VGA or DVI port (the type of connection
supported depends on your computer’s configuration). The appropriate
cable is usually included with the monitor.
Follow these steps to connect an monitor to your computer:
1. Check that the computer is powered off and the monitor power switch is

turned off.

2. Attach the video cable to the monitor port on the computer. Secure the

cable connection with the screws provided.

3. Connect the monitor power cable and plug it into a properly grounded

wall outlet.

4. Follow any setup instructions in the monitor's user's guide.
5. Turn on power to the monitor, then the computer.
6. Make sure that the current resolution and refresh rate do not exceed the

specifications of the monitor. If necessary change the display settings
used by the computer.

Note: To access the display controls: Click on Start, Control Panel,
Appearance and Personalization. Click on the Display category,
then select Change Display Settings.

Advertising
This manual is related to the following products: