Banks Power DynaFact pillar-style gauge mount '03-05 Dodge 5.9L Cummins Truck - Manual (Page 3)

Note: Due to normal manufacturing
processes you may have “flashing” (small
fibers of plastic) around the pod holes.
Once the gauge(s) are installed in the pod
you will not be able to see the flashing.
This Banks DynaFact Pillar-Style Gauge
Mount is to be installed on the driver’s
side a-pillar.
1.
Prior to inserting the gauge into the
Gauge Mount, place the plastic gauge
retaining cup in the Gauge Mount.
2.
To install the gauge into the Gauge
Mount, insert the terminal side of the
gauge through the mount and into the
plastic retaining cup. Correctly orient
the gauge so the gauge will be in the
proper orientation when the pillar
mount is installed onto the a-pillar.
Some holes on the Gauge Mount might
need to be slightly enlarged in order to
install the gauges. Using medium grit
sandpaper, a round file or a deburring
tool, SLOWLY enlarge the hole. BE
CAREFUL AND CHECK FIT OFTEN. The
plastic material is easily removed. We
recommend that you sand slightly and
then check the fit, repeating the
process until you have a desired fit.
Note: On some applications it may be
necessary to install the supplied plastic
spacer ring between the gauge face and
the Gauge Mount to provide clearance
on the backside of the gauge. Simply
slide the ring onto the gauge prior to
inserting it into the mount. Align the
keying cutout on the ring with the key on
the gauge. The ring shall be flush with
the gauge when installed correctly.
3.
Use the two (2) supplied plastic
nuts to securely fasten the gauge to
the pillar mount by installing them
onto the studs that are extended out
of the retaining cup. See
Figure 1.
Banks DynaFact ® Pillar-Style Gauge
Mount Installation
Figure 1
96519 v.2.0
3