Banks Power DynaFact pillar-style gauge mount '03-05 Dodge 5.9L Cummins Truck - Manual (Page 5)

96519 v.2.0
5
9.
Run Gauge lines down toward the
OttoMind/Six-Gun Module and follow
the instructions provided with the
gauge(s) for proper installation.
10.
Place the modified a-pillar trim
onto the a-pillar. Place the Banks
DynaFact Pillar-Style Gauge Mount on
top of the a-pillar trim. Install and
secure the unit using the provided
bolt. Insert the bolt through the hole
on the top of the Gauge Mount and
into the screw hole on the a-pillar. See
Figure 2.
11.
Reinstall the side cover onto the
instrument panel.
12.
Reinstall the weatherstrip. Note:
Make sure the weatherstrip is installed
properly to avoid water leaks. Do not use
sharp object to reinstall the weatherstrip
to avoid damaging or puncturing it.