Banks Power Interface- Banks iQ 2.0 1996 & Later Vehicles with OBDII Diagnostics User Manual

Page 12

Advertising
background image

12

97273 v.2.0

1.

Locate the Window Mount Assembly

in your kit.

2.

Assemble the Banks iQ mounting

plate to the window mount by inserting
and sliding the window mount tabs
into the mounting plate grooves. Hand
tighten the nut behind the mounting
plate to hold the mounting plate in place.

3.

Attach the window mount to your

Banks iQ. See Figure 3. Align and place
the two (2) lower tabs on the window
mount to the corresponding slots on the
bottom of the iQ first then snap the top
of the iQ into place.

4.

Find a suitable place on the

windshield for ease of access and
viewing of Banks iQ. Use location

shown in Figure 4 as a reference for
mounting Banks iQ in your vehicle.
Loosen the knob and move the swivel
suction plate to achieve desired viewing
angle of the Banks iQ screen. Do a test
fit and note the angle necessary to
achieve the correct viewing angle.

5.

Make sure the suction cup and the

mounting area on the windshield are
clean and dry. With the suction lever
in the up position, ensure the suction
cup is flat against the windshield, and
then push the suction lever down to
secure in place.

Connecting Banks iQ

6.

Locate the OBD II connection port in

your vehicle. The OBD II connection port
is located under the dash panel and can
be located on either side of the steering
wheel.

7.

Locate the Banks com-link

communication Bridge and connect the
Banks OBD II connector to the vehicles
OBD II connector. See Figure 5.
NOTE: For some vehicle models the
OBD II connection port may need to be
disconnected from its mounting location.
Unclip or remove factory screws/bolts
to relocate the OBD II connection port
and allow the Banks OBD II connector to
plug into the vehicles OBD II connector
without bending or putting stress on the
iQ Bridge Module harness. Secure the
OBD II connection port under the dash.

8.

Route the Banks iQ USB interface

cable on the com-link to reach the
Banks iQ.
NOTE: You may need to loosen or
remove dash panel or covers to install
the interface cable between dash crevice
or behind dash panels.

Section 3

MOUNTING AND CONNECTING THE BANkS iQ

Advertising