Banks Power GM Motorhomes: (Gas ’01 - 10 8.1L Workhorse) Intake- Ram-Air Intake system '01-08 Class-A MH User Manual
Page 15
17.
Locate the supplied MAF to intake
tube hose (Item 6) with the square
notch cutout and the MAF sensor
attached to Banks Ram-Air filter cover.
Slide the MAF to intake tube hose onto
the MAF sensor. Make sure the square
notch cutout and the tab on the MAF
sensor line up and fit snug. Tighten the
hose clamp (Item 2) to secure the MAF
to intake tube hose to the MAF sensor
but leave the hose clamp on the other
end of the hose adapter loose. See
Figure 14.
18.
Under the right wheel well, install
the Banks Ram-Air filter into the air
box. Install the Banks Ram-Air filter
cover, with attached components, to
the Banks Ram-Air intake tube (Item
5). Slide the two components together
until the hose adapter is against the
stops on the Banks Ram-Air inlet tube.
Once correct alignment is achieved,
install Banks Ram-Air filter cover into
place on the air box. Fasten the three
clips to secure it. See Figure 15.
19.
Locate the MAF sensor connector
terminal previously disconnected in
step 4. Plug in the connector to the
MAF sensor.
20.
Go over entire air intake system
and ensure all hose clamps and hose
adapters are correctly aligned. Fasten
the Banks Ram-Air intake tube by
installing the barbed plastic clip (Item
4) through the existing hole in fan
shroud and intake tube mounting tab.
See Figure 16. After barbed plastic
clip is installed, tighten all hose clamps
installed in previous steps.
21.
Place the intake snorkel (Item
20), on a sturdy flat surface, on the
its front (snorkel down and outlet up).
Locate the supplied snorkel outlet
adapter (Item 19) and slip over the
stock snorkel outlet. See Figure 17.
Figure 17
96430 v.4.0
15