Banks Power GM Motorhomes: (Gas ’01 - 10 8.1L Workhorse) Intake- Ram-Air Intake system '01-08 Class-A MH - Manual (Page 9)

7.
Loosen the hose clamp securing
the MAF sensor to the air filter cover.
Remove the MAF sensor from the
hose attached to the air filter cover
and place in a clean and safe area.
See Figure 7. Unclip air filter cover
(3 clips) and remove it from the air
box. Remove the air filter. If you have
a stock air filter, it may be discarded.
If you already have a Banks Ram
Air filter element (Item 11), service
it, if required, and set aside for
reinstallation later.
8.
The air box (Item 14) and bracket
must be removed for modification.
There are 4 bolts securing the air box
bracket to the frame. These bolts are
accessed from under the right wheel
well. Loosen and remove the bolts,
then remove air box and bracket
from the vehicle. Depending on your
specific coach model, it may be
necessary to loosen and remove two
bolts that fasten the bracket for the air
inlet snorkel to the frame. The bolts
are located behind the strap that held
the air inlet snorkel. Retain the bolts;
they will be used later for reassembly.
See Figure 8.
9.
Locate the plastic retaining pin on
the air box and remove with a prying
device. See Figure 9. Grab hold of
the rubber hose attached to air box
inlet adapter and the pry the adapter
off the air box. Note: the air box inlet
adapter is a snap fit removable piece.
Remove it carefully. The air box inlet
adapter and attached hose will not be
used and can be discarded.
10
. Place the air box on a flat, sturdy
surface, with the filter opening face
down. Locate the air box inlet adapter
(Item 16). Fit the air box inlet adapter
in place over the inlet opening.
Note: the air box bracket will slightly
interfere but will not prevent the
proper alignment of the air inlet
adapter with the opening on the air
box. The air box inlet adapter will be
Figure 7
96430 v.4.0
9