Banks Power GM Motorhomes: (Gas ’01 - 10 8.1L Workhorse) Intake- Ram-Air Intake system '01-08 Class-A MH User Manual
Page 20
Notification
The Banks Ram-Air Filter comes
pre-oiled and no oiling is
necessary for initial installation.
Use Banks Ram-Air Filter cleaning
system (part# 90094), available
from Gale Banks engineering to
service the Ram-Air Filter. Follow
the instructions included with
the cleaning system to clean and
re-oil your Banks Ram-Air FIlter.
1.
PRe-CLeANING
Tap the element to dislodge any large
embedded dirt, then gently brush with
a soft bristle brush. NOTE: If complete
cleaning is not practical at this time,
reoil the element and reinstall in your
vehicle.
2.
SPRAy-ON CLeANING
Spray Banks air-filter cleaner liberally
onto the entire element
and let
soak for 10 minutes.
PAN CLeANING
Large air-filter elements can be
rolled or soaked in a shallow pan
of Banks air-filter cleaner. Remove
immediately and let soak for
approximately 10 minutes.
3.
CLeANING hINTS
Use only Banks air-filter cleaner. No
gasoline cleaning, No steam cleaning,
No caustic cleaning solutions, No
strong detergents, No high-pressure
car wash, No parts cleaning solvents.
Any of these No’s can cause harm to
the cotton filter media plus SHRINK
and HARDEN the rubber end caps.
4.
RINSe OFF
Rinse off the element with low-
pressure water. Tap water is okay.
Always flush from the clean side to
dirty side. This removes the dirt
and does not drive it into the filter.
Section 3
RAM-AIR FILTeR CLeANING INSTRUCTIONS
20
96430 v.4.0