Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1391 - Manual (Page 15)

15
Assembly
PNEG-1391 8",10", & 12" BE-SAW Augers
1. ASSEMBLE 8" & 10" HOPPER AND INCLINE TUBE (CONT.)
Hopper Flight
1/2" x 1-1/4" Long (Grade 5)
Hex Head Cap screw with Flat
Washers and Nylon Locknuts
Note: Install so bolt heads are
on the inside.
Incline Tube
Bearing
Stub
U-Joint
Tail Stub
3/16" x 1-1/2"
Long Cotter Pin
2 Flat
Washers
Hopper Wheel
5/16" x 3/4" Long (Grade 5) Hex
Head Cap screws, Flatwashers,
and Nylon Locknuts
Hinged
Cover Incline
Flight
Cover Strap
3/8" Locknuts
Hopper Wheel
Hopper
Rubber Sleeve
Hanger
Bearing
The hopper hanger bearing and
bearing stub are preassembled to the
flexible swing-out hopper. In this
assembly drawing, those parts were
exploded away from the hopper to
better show the proper assembly of
the other parts.
F. Attach the lower end of the incline tube to the
front of the flexible swing-out hopper using the
following hardware:
•
Two (2) 1/2" x 1-1/4" long (Grade 5) hex
head cap screws
• Four (4) Flat washers
• Nylon locknuts
G. Install the bolt heads onto the inside but DO
NOT tighten completely because the coupler
box must be allowed to pivot.
H. Center hanger bearing on bearing shaft
between hopper flight and u-joint, then tighten.
Swing Out Hopper
FIGURE 1-B
I. Fasten the hinged cover to the front of the
flexible swing-out hopper using two (2) 5/16"
x 3/4" long (Grade 5) hex head cap screws,
flat washers, and nylon locknuts.
J. Install the cover strap over the lid onto the
3/8" stub, which is welded to the box on the
lower end of the incline tube. Use 3/8" nylon
locknuts to hold the straps on the stud.
2 Flat
Washers
Coupler
Box
8" - 5/16"x 2-1/2"
10" - 3/8" x 3"
8" & 10" Standard Profile Hopper Assembly
IMPORTANT: DO NOT
tighten the locknuts down.
The hinged cover must be
able to slide under the
strap when the incline tube
is tilted at different angles.