Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1391 - Manual (Page 24)

24
Start-Up
PNEG-1391 8",10", & 12" BE-SAW Augers
1. DESIGNATE WORK AREA
A. Before starting the auger, establish the
designated work areas. Figure 6 below shows
where boundaries should be established.
B. Mark off the designated work areas using
colored nylon or plastic rope as portable
barriers.
RULES FOR SAFE WORK AREA
Under no circumstances should persons not
involved in the operation of the auger be
allowed to trespass into the designated work
area. It is the duty of ALL operators to
ensure that children and/or other persons
stay out of the work areas. Should anyone
not involved in the operation trespass into
the work area or into a hazard area, the
operator should immediately shutdown the
auger.
It is the responsibility of ALL operators to
ensure that the work area has secure
footing, and is clean and free of debris and
tools that might cause accidental tripping or
falling. The operator is also responsible for
keeping the work area clean and orderly
during operation of the auger.
Auger Intake
Area: Keep Out!
Walking Surface: Is it
slippery? Are there things
that might trip you?
Work Area: Authorized
Personnel Only
BE-SAW Auger
Wagon
or Truck
Overhead Wires:
Keep Away!
FIGURE 6
2. INSPECT THE AUGER
A. After your new auger is delivered and assem-
bly is complete, and before each use, you
must inspect the auger.
B. Be sure that ALL guards listed in the assem-
bly instructions are in place, secured, and func-
tional.
C. Check ALL safety decals. Replace any that
are worn, missing, or illegible. A list of decals
found on the auger is included in the front of
this manual. You may obtain decals from your
dealer or order direct from the factory.
D. Ensure that ALL fasteners are tight.
E. Ensure that the inspection covers are in place.