Rainbow Electronics ATtiny12 - Manual (Page 39)

39
ATtiny11/12
1006C–09/01
Analog Comparator
The Analog Comparator compares the input values on the positive input PB0 (AIN0) and
negative input PB1 (AIN1). When the voltage on the positive input PB0 (AIN0) is higher
than the voltage on the negative input PB1 (AIN1), the Analog Comparator Output
(ACO) is set (one). The comparator’s output can trigger a separate interrupt, exclusive
to the Analog Comparator. The user can select interrupt triggering on comparator output
rise, fall or toggle. A block diagram of the comparator and its surrounding logic is shown
in Figure 26.
Figure 26. Analog Comparator Block Diagram.
Analog Comparator Control
and Status Register – ACSR
Note: AINBG is only available in ATtiny12.
• Bit 7 - ACD: Analog Comparator Disable
When this bit is set (one), the power to the Analog Comparator is switched off. This bit
can be set at any time to turn off the Analog Comparator. When changing the ACD bit,
the Analog Comparator Interrupt must be disabled by clearing the ACIE bit in ACSR.
Otherwise an interrupt can occur when the bit is changed.
• Bit 6 - AINBG: Analog Comparator Bandgap Select in ATtiny12
In ATtiny12, when this bit is set, a fixed bandgap voltage of 1.22 ± 0.05V replaces the
normal input to the positive input (AIN0) of the comparator. When this bit is cleared, the
normal input pin PB0 is applied to the positive input of the comparator.
• Bit 6- Res: Reserved Bit in ATtiny11
This bit is a reserved bit in the ATtiny11 and will always read as zero.
• Bit 5 - ACO: Analog Comparator Output
ACO is directly connected to the comparator output.
• Bit 4 - ACI: Analog Comparator Interrupt Flag
This bit is set (one) when a comparator output event triggers the interrupt mode defined
by ACI1 and ACI0. The Analog Comparator Interrupt routine is executed if the ACIE bit
is set (one) and the I-bit in SREG is set (one). ACI is cleared by hardware when execut-
ing the corresponding interrupt handling vector. Alternatively, ACI is cleared by writing a
logic one to the flag.
INTERNAL
VOLTAGE
REFERENCE
(ATtiny12 ONLY)
MUX
AINBG
Bit 7 6 5 4 3 2 1 0
$08 ACD (AINBG) ACO ACI ACIE - ACIS1 ACIS0 ACSR
Read/Write R/W R(/W) R R/W R/W R R/W R/W
Initial Value 0 0 X 0 0 0 0 0