PowerWalker WinPower Software V.4.3.0.1 Quick Guide - Manual (Page 2)

C. If the WinPower is running and you execute the software again then you would see a message for
“Minimize” or “Exit”. The message is also shown as below. If you can see it then it means that you
already execute the software twice.
D. After you start the system and the WinPower is also running in the Traybar, you have to use “Right
Click” on the Green Plug then click on “Start the Monitor “to switch on the main screen of the
software.
E. After step D, you would see the screen is switching on as below message. After it runs to 100% you
will see the main screen of the software.
Right Click here then click
on “ Start Monitor “