PowerWalker WinPower Software V.4.3.0.1 Quick Guide User Manual
Page 6
detect all the PC which is installed the WinPower and show them in the left window of WinPower
as above photo for cs2000, g300, backup, hp-e800 & smartups automatically.
Notes: “Same section of network” means the three front numbers of its IP address is the same just like
192.168.1.XXX.
5. If the IP address is out of the same section of the Agent, you have to key-in the IP manually for
doing the remote monitor/control via “Monitor”->”Monitor Remote Device”
6. There are two major parts of the sheet of “Shutdown Parameter” in the WinPower as below.
7. There are three items will effect the UPS backup time of the local Agent as below.
A. Battery Backup Time (AA minutes)
B. Begin shutdown immediately while battery low
C. System shutdown need time (CC minutes)
7-1. In normal status, when the backup time reaches the value of AA minutes, the WinPower would send the
command to shutdown the PC. After the CC minutes, the UPS would also shutdown automatically. It means
the UPS will work in battery mode for AA+CC minutes.
This part is used for the
local Agent only.
This part is used for
the remote PC