R&M Materials Handling ELECTRIC CHAIN HOISTS LoadMate Chain Hoist LM 16-20-25 - Manual (Page 33)

LM16-20-25 I&M MANUAL/EN/11.30.2010
33/73
This document and the information contained herein, is the exclusive property of R&M Materials Handling, Inc., and represents a non-public, confidential and proprietary trade secret that
may not be reproduced, disclosed to third parties, altered or otherwise employed in any manner whatsoever without the express written consent of R&M Materials Handling, Inc.
Copyright © (2010) R&M Materials Handling, Inc. All rights reserved.
6.9 Fall Stop Assembly (Refer to Figure 14)
The slack fall stop is a safety stop, not a functional stop. The fall stop must be located at least six
(6.0) inches [150mm] from end of last chain link.
Figure 14. Cross Section of Slack Fall Stop
P25019
LM 16 LM 20 / 25
Removing Fall Stop Assembly
1. Loosen and remove nut (two each for LM 20/25 )
2. Remove bolts.
3. Remove two halves of Fall Stop.
4. Remove limit switch washer plate and spring.
Installing Fall Stop Assembly
1. Install limit switch washer plate and spring unto chain. Make certain washer is in proper position to
contact limit switch.
2. Place two halves of Fall Stop at least six (6) inches [150mm] from end of chain.
3. Insert bolt and tighten nut (two each for
LM 20/25 )