SOLO 416 Rückentragbare Akku-Druckspritze - Manual (Page 32)

Operating and maintenance instructions
ENGLISH 16
8.5 Draining and cleaning the solution tank
Draining the solution tank
 Place the backpack sprayer level on a
horizontal surface.
 Rotate the two locking buttons (17)
approximately 100° anti-clockwise to release
the protective casing.

Open the protective casing.
 Hold the end of the discharge hose (19) into a
suitable container.
 Open the drain valve (18) (the lever should be
set parallel to the hose).
 After draining: Close the drain valve (the lever
should be set at right angles to the hose) and
reattach the discharge hose to the rear panel.
 Close the protective casing and twist the
locking buttons back in a clockwise direction
until they are horizontal.
Drain the solution tank daily after use and
thoroughly flush it with water. Please read and
observe the cleaning instructions in the
instructions for use supplied with the pesticide. We
recommend the use of the special SOLO cleaner
for pesticide sprayers that is available in 500 ml
dosing bottles. Part no.: 4900600
Clean the filling strainer, the ball valve filter at the
spraying nozzle and the spraying nozzle
periodically with water using a soft brush. Do not
use your mouth to blow through the spray nozzle!
After cleaning, leave the solution tank open to dry.
8.6 Taking the sprayer out of service and
putting it into storage
Work through the steps in section 8.5 "Draining
and cleaning the solution tank" to prepare the
device for storage.
Store the device in a secure, dry and frost-free
location under a maximum ambient temperature of
35°C.
There must not be any open fires or similar nearby.
Even when the unit is not in use, regularly recharge
the battery (and the spare battery if you have one)
once a month with the supplied charger.
Ensure that the unit cannot be used by
unauthorised persons, in particular children.