SENA Parani-ESD100-110-200-210 - Manual (Page 10)

10
2. Getting Started
This chapter describes how to set up the Parani-ESD Series for the first time.
- 2.1 Panel Layout explains the panel layout.
- 2.2 Connecting the Hardware describes how to connect the Parani-ESD Series, the power, and the
serial device to the Jig Board.
Following items are pre-required to get started.
- One Jig Board (included in the Starter Kit package).
- One DC power adapter or one USB power cable (included in the Starter Kit package).
- One serial console cable for configuration (included in the Starter Kit package).
- One PC with RS232 serial port.
- Terminal emulation program running on the PC
2.1. Panel Layout
This section describes the panel layout of the Jig Board.
Figure Error! Style not defined.-1 The panel layout of Jig Board
2.2. Connecting the Hardware
This section describes how to connect the Parani-ESD Series to the Jig Board and the Jig Board to
the serial device for initial testing.
- Connect the Parani-ESD Series to the Jig Board.
- Connect a power source to Jig Board for the Parani-ESD Series.
- Connect Jig Board for the Parani-ESD Series to a serial device.