SENA Parani-ESD100-110-200-210 - Manual (Page 45)

45
Description Parani-ESD can have a user friendly name for easy identification. The name allows up to
30 alpha-numeric characters.
Reference AT+BTINFO?, AT+BTINQ?
Example AT+BTNAME=”My-Parani-ESD”
B.3.29. AT+BTLPM,n

Response  OK
Purpose Set low power mode
Parameters n=0: Inactivate (Default)
n=1: Activate
Description During no data transmission, Parani-ESD can be in low power mode to save the power. It
takes a few seconds to wake the Parani-ESD out of low power mode.
B.3.30. AT&V

Response  S0:m0;S1:m1; …Sn:mn
 OK
Purpose Display all the S-register
Description All parameters are stored at S-register in flash memory. These values are sustained until
hardware reset.
Reference ATS
B.3.31. ATSnn?

Response  value
 OK
Purpose Display a given S-register
Parameters nn= Address of S-register
Description A specific S-register will be displayed.
Reference AT&V
B.3.32. ATSnn=mm

Response  OK
Purpose Change S-register value
Parameters nn= Address of S-register
mm= New value of S-register
Description Some S-registers are optimized for the overall performance and protected and cannot be
changed. When users try to change these S-registers, response is ‘ERROR’.
For details of S-register, refer Appendix. B.
Reference AT&V
Example ATS10=0