SENA Parani-ESD100-110-200-210 - Manual (Page 49)

49
the optimal value. If the intercharater timeout is set below the optimal value, the data will be put
together and sent by 20, 30, 40 bytes or more.
C.15. S28: Escape Sequence Character (default 43)
The decimal number of the ASCII code of escape sequence character can be controlled. The initial
value is 43, the ASCII code of ‘+’.
C.16. S31: Page Timeout (default 300)
This is the timeout in seconds to attempt connection with the ATD command. After this timeout expires,
the Parani-ESD will restart automatically. If this value is 0, Parani-ESD will attempt to connect without
restarting
C.17. S33: Inquiry Timeout (default 30)
This is the timeout in seconds to execute inquiry scan.
C.18. S37: Supervision Timeout (default 16000)
This is the timeout in 625μsec to presume disconnection, which is set to 16000 initially.
(16000
 625μsec=10sec)
The smaller the value becomes, the more quickly Parani-ESD can detect an abnormal disconnection.
But when the communication is suspended, it may be regarded as disconnection.
C.19. S43: COD (default 001F00)
This is the value of COD. Default value is 001F00(Uncategorized, specific device code not specified).
C.20. S44: COD Filter (default 000000)
This is the value of inquiry COD filter.
Ex) ats44=001c00
C.21. S45: IAC(Inquiry access code)
The reserved IAC addresses are 0x9E8B00 ~ 0x9E8B3F. The general inquiry IAC is 0x9E8B33. So
default value is 0x9E8B33.
C.22. S46: BD Address of Last Connected Device
This saves the BD address of the Bluetooth device connected most recently.
C.23. S47: Select Low Power Mode (default 0)
S47=0, Select Park Mode
S47=1, Select Sniff Mode
When this value is 0, Parani-ESD works only in park mode. When Parani-ESD works in park mode,
delay in transferring data may occur. And if the value is 1, Parani-ESD works in sniff mode. Parani-
ESD works always low power mode but the data will be put together.