SENA ProBee-ZU10 - Manual (Page 11)

11 ProBee-ZU10 User Guide Rev.1.5
2 Getting Started
Creating a ZigBee network using the ZU10 adapters consists of the following steps:

Connect the ZU10 adapter to a computer

Create a ZigBee network by configuring a ZU10 adapter as the coordinator

Configure ZU10 adapters as routers. This step is optional since the coordinator works as a router
too.

Configure ZU10 adapters as end-devices

Transmit data between ZU10 devices
This chapter describes how to install the ZU10 adapters and how to use terminal software programs to
access the ZU10 adapters using AT commands for configurations and operations. The rest of the steps
including ZigBee network creation, coordinator/router/end-device configurations and data transmissions
are described in the following chapters. The more detailed information on the panel and the configuration
examples are also provided in the later chapter.
2.1 Hardware Installation
2.1.1 Panel Layout
Figure 2-1 shows the layout of the panel. The panel provides the interface between the ZU10 and the
external USB port with input/output terminals for convenient tests.
Figure 2-1 Panel Layout of ZU10