SENA ProBee-ZU10 - Manual (Page 60)

60 ProBee-ZU10 User Guide Rev.1.5
7.3.4 S34
Description
Get/Set the indirect transmission timeout in milliseconds. It is the maximum amount of
time that the MAC will hold a message for indirect transmission to a child.
Execute ATS34?<CR> ATS34=<value><CR>
Response
<value><CR>
OK<CR>
OK<CR>
Default 3000
Range 0 – 30000
7.3.5 S35
Description
Get/Set the broadcast range. ZigBee specifies three different broadcast addresses that
reach different collections of nodes. Broadcasts are normally sent only to routers.
Broadcasts can also be forwarded to end-devices, either all of them or only those that
do not sleep. Broadcasting to sleepy end-devices is both significantly more resource-
intensive and significantly less reliable than broadcasting to routers.
0: send to all routers
1: send to all non-sleepy nodes
2: send to all nodes in the network
Execute ATS35?<CR> ATS35=<value><CR>
Response
<value><CR>
OK<CR>
OK<CR>
Default 2
Range 0 – 2
7.3.6 S36
Description
Get/Set the maximum number of hops the message will be relayed. The message will
be delivered to all nodes within this number of hops of the sender. A value of zero is
converted to maximum value(30). It is used to multicast/broadcast.
Execute ATS36?<CR> ATS36=<value><CR>
Response
<value><CR>
OK<CR>
OK<CR>
Default 0
Range 0 – 10
7.3.7 S37
Description
Get/Set the number of hops that the message will be forwarded by devices that are not
members of the group. A value of zero, 7 or greater is treated as infinite. There is no
longer a separate limited multicast API call.