SCANTECH ID (Champtek company) SG20 - Manual (Page 10)

Interface Manual Scantech SG-20 Discovery WLAN Rel 1.1 8
3 Configure the WLAN 802.11b settings
The WLAN module inside the SG20 can operate in three interface modes:
1. 10/100 Mbit Wired LAN.
2. 802.11b/g WiFi.
3. Ethernet<->WLAN bridge.
To choose one of these modes, select '0' from the main menu.
This shows the following question:
Network Mode (0=Wired Only 1=Wireless Only 2=Bridging(One Host) [0]
Choose '1' for wireless.
The options, which will pop up next, are discussed in chapter 4.
3.1 From the main menu, select a 4 to configure the 802.11b/g settings
of the WLAN module.
In the following fields, all text between "[ ]" indicate the current setting of the
particular field. The used values are not necessarily the same as your own WLAN
module. Also, the options may differ depending on your choices.
3.2 Network name [SCANTECHID] ?
This is the SSID which should correspond with the SSID your access point is using.
3.3 Security 0=none, 1=WEP , 2=WPA [0] ?
If '1' is entered, you get the following options for WEP:
3.3.1. Authentication 0=open/none, 1=shared [1] ?
3.3.2. Encryption 0=WEP64, 1=WEP128 [0]?
3.3.3 Display current key [N] ?
If 'Y' is entered, the current key will be shown.
3.3.4 Change Key [N] ?
Choose 'Y' to change the key.
If '2' is entered, you get the following options for WPA:
3.3.5 Group encryption 1=WEP64, 2=WEP128, 3=TKIP [3]?
3.3.6 Display current key [N] ?
If 'Y' is entered, the current key will be shown.